(Easy Install)
These overlays cover the CLEAR part of the taillight only.
Set of 2 rear overlays
Upgrade the look of your vehicle without breaking the bank. Instead of costly taillight replacements or paint, Vinyl Flare’s premium taillight tint overlays offer a clean, modern finish with an easy DIY application. Designed to enhance your rear end with a sleek, smoked look, these overlays provide a stealthy aesthetic that instantly elevates your ride.
Each pre-cut piece is precision-engineered to match your taillight’s shape, making installation smooth, bubble-free, and stress-free — no cutting or trimming needed.
Product Highlights
• Smoked, tinted film designed for taillight overlays
• Pressure-activated adhesive for easy sliding and repositioning
• Long-lasting durability with a 9-year expected life span
• Available in multiple shades and transparency levels
• Ideal for flat or slightly curved taillight surfaces
Installation Instructions
Step 1: Surface Prep
• Clean the taillights thoroughly with mild soap and dry with a lint-free cloth.
• Use isopropyl alcohol to remove any grease or wax.
• Recommended temperature: 50°F–77°F for best adhesion.
Dry Application Method
Step 2: Positioning
- Align the pre-cut overlay with your taillight.
- Use small masking tape pieces to hold in place and test fit.
Step 3: Apply Overlay
- Peel the backing without stretching the vinyl.
- Apply from one side, smoothing with a squeegee or microfiber-covered finger.
- Press firmly to eliminate air pockets.
Step 4: Heat & Seal
- Gently heat with a heat gun or blow dryer to soften the vinyl.
- Work the edges and curves for a tight, finished look.
- Remove any last bubbles with light pressure.
Wet Application Method
Step 2: Make Application Fluid
• Mix a few drops of dish soap in a spray bottle of water.
• Lightly mist both the taillight and adhesive side of the overlay.
Step 3: Position Overlay
- Peel the backing and spray the adhesive side.
- Place overlay on the taillight and adjust as needed.
Step 4: Apply & Set
- Squeegee from center outward to remove bubbles and water.
- Continue smoothing until secure and flush.
Step 5: Final Seal
- Let sit for 15–20 minutes.
- Warm gently to activate adhesive and finalize the bond.
- Press edges for a clean finish.