Lexus Tint Overlay for Front and Rear Emblems

(Easy Install)

 “Lexus Models ” category includes all other Lexus vehicles from that same model year, except for the ones specifically separated into their own categories in the listing such as the LC, GS F, and RC F.

Upgrade the look of your vehicle without breaking the bank. Instead of costly emblem replacements or paint, Vinyl Flare’s premium tint overlays offer a clean, modern finish with an easy DIY application. Designed to enhance both front and rear emblems, these overlays provide a stealthy aesthetic that instantly elevates your ride.

Each pre-cut piece is precision-engineered to match your emblem’s shape, making installation smooth, bubble-free, and stress-free — no cutting or trimming needed.

✨ Product Highlights

• Smoked, tinted film designed for emblem overlays
• Pressure-activated adhesive for easy sliding and repositioning
• Long-lasting durability with a 9-year expected life span
• Available in multiple shades and transparency levels
• Ideal for flat or slightly curved emblem surfaces

🛠 Installation Instructions

🔹 Step 1: Surface Prep

• Clean the emblem thoroughly with mild soap and dry with a lint-free cloth.
• Use isopropyl alcohol for any grease or wax.
• Recommended temperature: 50°F–77°F for best adhesion.

🔹 Dry Application Method

Step 2: Positioning

1. Align the pre-cut overlay with your emblem.
2. Use small masking tape pieces to hold in place and test fit.

Step 3: Apply Overlay

1. Peel the backing without stretching the vinyl.
2. Apply from one side, smoothing with a squeegee or microfiber-covered finger.
3. Press firmly to eliminate air pockets.

Step 4: Heat & Seal

1. Gently heat with a heat gun or blow dryer to soften the vinyl.
2. Work the edges and curves for a tight, finished look.
3. Remove any last bubbles with light pressure.

🔹 Wet Application Method

Step 2: Make Application Fluid

• Mix a few drops of dish soap in a spray bottle of water.
• Lightly mist both the emblem and adhesive side of the overlay.

Step 3: Position Overlay

1. Peel the backing and spray the adhesive side.
2. Place overlay on emblem and adjust as needed.

Step 4: Apply & Set

1. Squeegee from center outward to remove bubbles and water.
2. Continue smoothing until secure and flush.

Step 5: Final Seal

1. Let sit for 15–20 minutes.
2. Warm gently to activate adhesive and finalize the bond.
3. Press edges for clean finish.