“Rest of Lexus Models” category includes all other Lexus vehicles from that same model year, except for the ones specifically separated into their own categories in the listing such as the LC, GS F, and RC F.
Upgrade the look of your vehicle without breaking the bank. Instead of costly emblem replacements or paint, Vinyl Flare’s premium tint overlays offer a clean, modern finish with an easy DIY application. Designed to enhance both front and rear emblems, these overlays provide a stealthy aesthetic that instantly elevates your ride.
Each pre-cut piece is precision-engineered to match your emblem’s shape, making installation smooth, bubble-free, and stress-free — no cutting or trimming needed.
✨ Product Highlights
Smoked, tinted film designed for emblem overlays
Pressure-activated adhesive for easy sliding and repositioning
Long-lasting durability with a 9-year expected life span
Available in multiple shades and transparency levels
Ideal for flat or slightly curved emblem surfaces
🛠 Installation Instructions
🔹 Step 1: Surface Prep
Clean the emblem thoroughly with mild soap and dry with a lint-free cloth.
Use isopropyl alcohol for any grease or wax.
Recommended temperature: 50°F–77°F for best adhesion.
🔹 Dry Application Method
Step 2: Positioning
Align the pre-cut overlay with your emblem.
Use small masking tape pieces to hold in place and test fit.
Step 3: Apply Overlay
Peel the backing without stretching the vinyl.
Apply from one side, smoothing with a squeegee or microfiber-covered finger.
Press firmly to eliminate air pockets.
Step 4: Heat & Seal
Gently heat with a heat gun or blow dryer to soften the vinyl.
Work the edges and curves for a tight, finished look.
Remove any last bubbles with light pressure.
🔹 Wet Application Method
Step 2: Make Application Fluid
Mix a few drops of dish soap in a spray bottle of water.
Lightly mist both the emblem and adhesive side of the overlay.
Step 3: Position Overlay
Peel the backing and spray the adhesive side.
Place overlay on emblem and adjust as needed.
Step 4: Apply & Set
Squeegee from center outward to remove bubbles and water.
Continue smoothing until secure and flush.
Step 5: Final Seal
Let sit for 15–20 minutes.
Warm gently to activate adhesive and finalize the bond.
